Sliding a heavy engine off a workbench and onto the floor is how cases get cracked and fingers get pinched. This engine cradle dolly supports up to 1,500 pounds and holds a motorcycle or ATV engine securely while you move it across the shop or store it between build sessions. The frame is welded carbon steel with a blue powder-coated finish that resists rust, oil, and the bumps that come with daily workshop use.The width and height of the cradle adjust to fit different engine sizes. Set the supports to match the case, lower the engine onto the rubber pads, and the load sits steady without rocking. The pads protect the engine from scratches and dents, so a freshly painted case stays clean. Four tie-down points let you strap the engine to the dolly for extra stability when rolling over uneven floors or into a trailer.Four 360-degree swivel casters let one person steer the dolly around lifts, toolboxes, and other projects. The casters roll smoothly on sealed bearings and do not mark sealed concrete or epoxy shop floors. When the engine is mounted and the job is done, the dolly slides under a workbench or against a wall for storage. Always check that tie-downs are tight and the cradle adjustment is locked before moving a loaded dolly.SpecificationsCapacity: 1,500 lbMaterial: Carbon steel frame, blue powder coatAdjustment: Width and height adjustableProtection: High-density rubber padsTie-Down Points: 4Wheels: 360-degree swivel castersIncluded1 × Engine Cradle Dolly1 × User Manual